Cap mould experience FAQ

Cap finger location not in the face of bottle!


Problem:

The rotate screw pin teeth not in a same position when install the mould.

   
Solutions: 1) First the rotate screw pin teeth should in a same position when install the mould. 2) When the mould run, the hydraulic motor run how much, the mould should run back the start position how much.
   

Problem again: Still have 1 or 2 cap not in the center of bottle

   
Solutions again: Must disassembly the mould than adjust the gear that have problem.
Contact Us


Phone: 00 86 137 1158 0480 E-mail: sale@gsdmfg.com Skype / WeChat: gosdar